Standard Yellow Grey

Standard Yellow Grey

SKU: G-MP801

Vendor: Milliput

Shop by Vendor: Milliput
  • €7.00 EUR


Perfect for gap filling, sculpting & model scratch building.
Milliput epoxy putty is produced in five grades: Standard Yellow/Grey, Silver Grey, Superfine White, Terracotta, and Black. Each grade is presented in similar packs containing 2 x 2 ounce (56.7 g) sticks and the general instructions for preparation and usage are the same.
The two sticks have a long shelf life but once mixed the resultant putty is at first soft and highly adhesive and then gradually hardens. Speed of hardening is dependent on temperature and at normal temperatures (20-25ºC) Milliput becomes rock hard in three to four hours. By the application of heat the setting time can be reduced to a few minutes.
After setting hard Milliput continues to cure and is fully cured after an elapse of time equal to the setting time at the same temperature. Once fully cured Milliput can be machined, drilled, tapped, turned, filed, sawed, sandpapered and painted. Milliput can be sandpapered and painted immediately it has set. (it is advisable to wear eye protection during this process).
Milliput is an excellent adhesive and will bond any of the following to itself or to any of the others - wood, brick, cement, metals, concrete, plastics, glass etc, but note that Milliput is not intended as a thin layer adhesive and should not be used where a paste, mucilage or thin glue is indicated. Milliput will set under water and is heat resistant up to 130°C.
It is recommended that Milliput be stored stored in cool, dry conditions. Bags should be resealed after use. Stored correctly, Milliput should remain workable for about 2 years.
Made in England.

We Also Recommend


Back to the top